MTX

Wind speed sensor

The sensor FAR203xx is provided with a Robinson 3 cup rotor which rotates around a vertical axis. This element is mounted on the top of the sensor body and is joint to an internal axis which is linked to stainless steel bearings with low friction in order to increase sensor sensitivity.

Coupled to the rotation axis, an optical transducer converts the rotation rate to a digital electric signal. The frequency of the impulsive signal is proportional to rotation rate of the rotor and so to wind speed.

The sensor body is made in anticorodal aluminum, a material which guarantees a substantial durability and high resistance to corrosion, making the instrument suitable for applications in marine environments.

The sensor provides a good response over the entire range of wind speed, it is able to detecting low intensity of wind and high speeds up to 50 m/s (corresponding to 180 km/h).

An electronic board, based on a low power 32bit microprocessor, allows the characterization of the sensor at several points within the operating range; this allows to linearize the response curve so as to elevate the accuracy of the instrument.

On the bottom end of the sensor there is a connector for the signal and supply cable. The connector is watertight and has a screw connection.

For the calibration of the sensor, a certified instrument is used (reference ACCREDIA). The calibration based on comparison allows to maintain continuity with the metrological chain and assigns a scientific value to the measurement.

The sensor requires minimal maintenance: at least once a year, it is recommended to check the regular rotation of the cup - wind mill, which must take place without any particular friction, but rather with the normal smoothness of a mechanical component rotating on bearings.

Optionally, a heating set is available in order to avoid the block of the rotor due to freezing.

Pdf Wind speed

ISO 9001
This site is optimized for the following browsers
Compatibilità broswer
MTX Srl - Head office
Via G.A. Longhin, 11
35129 Padova (PD) Italy
C.F. - P.IVA - R.I. 04343730281
R.E.A. PD 382120
Capitale sociale: 100.000,00 Euro i.v.
PEC: This email address is being protected from spambots. You need JavaScript enabled to view it.
MTX Srl - Headquarters
Via Zamboni, 74 - 41011
Campogalliano (MO) Italy
Ph. +39 059 2551150
Fax. +39 059 527143
R.E.A. MO 370886
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.